Author Topic: Thorn 200W HO SLI Ballast question  (Read 499 times)
Sr. Member

Gender: Male
View Posts
View Gallery

I like yellow light

Thorn 200W HO SLI Ballast question « on: September 06, 2020, 08:37:03 PM » Author: 589
I have one of these that I have already lit and run up on my Fulham workhorse 8 in F96T12VHO configuration successfully (Link below). Total system wattage is 180-190w on it, so a little under-run. I have since purchased a single lamp VHO rapid start ballast to possibly run it up on. I was curious about electrode pre-heating since this lamp has beehive electrodes. Would this be detrimental to them or the ballast if I had both wires to the socket to enable pre-heating? Thanks!

LPS bulb

© 2005-2020 | Powered by SMF 1.1.21 | SMF © 2015, Simple Machines